Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Technical specifi cations of the NEOMAT-MT and NEOMAT-LT tubular
motors
• Supply Voltage and Frequency: See the technical data on the label attached to each
model
• Current and power: See the technical data on the label attached to each model
• Torque and speed: See the technical data on the label attached to each model
• Motor diameter: NEOMAT-MT = 45mm; NEOMAT-LT = 58mm
• Precision (Resolution) of the electronic limit switch: greater than 0.55° (depending
on the NEOMAT-T version)
• Precision of the stop positions: Class 2 (±5%)
• Mechanical resistance: in accordance with EN 14202
• Continual operating time: Maximum 4 minutes
• Protection class: IP 44
• Working temperature: -20 °C
• Length of connection cable: 3 m
• Signal voltage (step-by-step, TTBUS...): Approx. 24 V
• Wind sensor (anemometer) levels: 5 approx. 5, 10, 15, 30 or 45 km/h (with VOLO
OR VOLO-S anemometer)
• Sun sensor levels: 5 approx. 5, 10, 15, 30 or 45 Klux (with VOLO-S)
• Length of signal cables (step-by-step, TTBUS...): max. 30m if near other cables,
otherwise 100m
• Radio receiver frequency: 433.92 MHz
• Radio receiver coding: 52 Bit rolling code FLOR and FLOR+INFO
• No. of transmitters that can be memorized: 14, including a maximum of 3 VOLO-S-
Radio climatic sensors
• Portata dei trasmettitori: Estimated 150 m in the open and 20 m inside buildings (*).
Note:
– (*) The range of the transmitters can be infl uenced by other devices operating in the
vicinity at the same frequency as the transmitter (for example radio headphones, alarm
systems etc.) causing interference with the receiver. In the event of strong interference,
Nice cannot provide any guarantee as regards the effective capacity of its radio devices.
– All technical characteristics refer to an ambient temperature of 20°C (± 5°C).
– Nice S.p.a. reserves the right to apply modifi cations to the product at any time when
deemed necessary, while maintaining the same functionalities and intended use.
12 – English
CE declaration of conformity
Nice S.p.A. hereby declares that the products: Neomat MT, Neomat LT
conform to the essential requisites and other pertinent provisions laid down
by directives 1999/5/EC, 2006/95/EC, 2004/108/EC. The CE declaration of
conformity can be consulted and printed at www.nice-service.com or requested
from Nice S.p.A.
Mr. Luigi Paro
(Managing Director)
Publicidad
Tabla de contenido
