Scene Mode - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Occupancy Sensor Setup

Scene Mode

This step allows you to assign up to four occupancy sensors to the GRAFIK Eye
control unit.
Selecting Sensors
Occ Sensor
1. If not already done, associate occupancy sensors and set to
Setup
"Scene Mode".
2. Use the Master buttons to highlight "Setup" and press the
Labels
OK button to accept. The info screen will display "Searching"
while the unit detects available occupancy sensors.
3. Use the Master buttons to scroll through the list of available
occupancy sensors. When the desired sensor is displayed,
Saved
Searching
press the OK button to select it. Then choose "Assign" or
"Unassign" from the following menu and press OK. Once a
sensor has been assigned, it will appear with an asterisk (*) in
the sensor list. Repeat for additional sensors.
Sensor x/y
Note: If wireless sensors are not found, verify that they are
xxxx-xxxx
Setting the Sensor Action
RF
1. Press the Timeclock (back) button to return to the Occ Sensor
screen. Use the Master buttons to highlight "Actions" and
press the OK button. By default, the occupied scene is set to
Assignment
"No Action" and the unoccupied scene is set to "Scene Off".
2. Use the Master buttons to highlight the scene you wish to
Assign
use for occupied status and press the OK button to accept.
Unassign
Repeat for the scene you wish to use for unoccupied status.
Press the OK button to accept.
3. Exit programming mode.
Saved
*Assigned*
Sensor *x/y Occ Sensor
xxxx-xxxx
Actions
3 seconds
RF
Setup
®
1 9
associated correctly.
Occupied Scene
Scene 1
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
2 10 3 11 4 12 5 13 6 14 7
QS
®
Unoccupied Scene
Scene Off
QS with DALI Control Unit Quick Installation and Operation Guide 17
®
15 8 16
9-16
1-8
OK
Saved
Saved
Master
buttons
OK
button
Timeclock
(back) button