Completing Installation Of The Grafik Eye - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Completing Installation of the GRAFIK Eye

1. Mount the control unit in the wallbox as
shown using the four screws pro vid ed.
Note: Follow all local and national
electrical codes when installing IEC
PELV wiring with line voltage/mains
wiring.
2. Verify installation:
• Restore power.
• Press the top scene button. The LED will
light.
• Press the zone raise and lower buttons.
Make sure the control unit is dimming all
connected loads.
3. Apply the protective overlay to the control
unit.
®
QS with DALI Control Unit
®
Protective overlay
(apply after installation)
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI Control Unit Quick Installation and Operation Guide 9
®
200 mm
87 mm
95 mm
Note: When tightening mounting
screws, make sure that the
hinged cover and faceplate
will open fully, as shown.
Wall