Fluorescent Lamp Disassembly Instructions; Door Lock Adjustment; Assembly Of Gearmotor Gears Fig. 14-15 - FAS 480 BUDGET Manual Del Usuario

24

10.5 FLUORESCENT LAMP DISASSEMBLY INSTRUCTIONS

E

10.6 DOOR LOCK ADJUSTMENT

N
G
L
I
S
H

10.7 ASSEMBLY OF GEARMOTOR GEARS FIG. 14-15

FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Door fluorescent lamp:
A) Switch the main switch off.
B) Release the fluorescent light unit from its supports.
C) Cut the wire fastening bands.
D) Remove the ends of the wiring.
E) Replace the fluorescent light.
F) Reassemble by proceeding in reverse order.
To obtain a different pressure of door locking operate on the grub screw placed under
the hole to which the lock bar is hooked (on the left side of the machione).
By turning the grub screw clockwise you obtain a tighter screwing up, by turning
anti.clockwise you loosen the locking.
1) Insert the shim washers in positions 1-2-3 (fig.15).
2) Insert the stiffened helical gear fig.14 rif. 8 Z=87, considering that the straight cut
pinion must be turned upwards.
3) Insert the shaft with straight-cut gear fig.14 rif. 7 Z=54.
4) Insert the helial gear on the side shaft fig.15 rif. 3 Z=46, considering that the straight
cut pinion must be turned downwards.
FIG. 14
480 Budget - Issue 00
FIG. 15