Systems Of Payment - FAS 480 BUDGET Manual Del Usuario

480 Budget - Issue 00
CHARACTER "F"
Character "F" appears when the machine is started:
(reset of the card carried out).
CHARACTER "H"
For machines equipped with a thermoregulator for the "refrigeration unit security control" option this letter
appears when the thermoregulator output signal is activated. It signals that the internal temperature of the
machine has exceeded the preset safety limit and therefore the products can no longer be sold.
CHARACTER "P"
Character "P" appears when an error has happened during the carrying out of the program for the
functioning of the card.
Disconnect and after some seconds connect again.
If at a certain moment the error happens again, replace the card.
CHARACTER "-"
Character "-" appears during the normal functioning of the machine; no bad functioning is found.
The following systems of payment can be mounted:
1) Coin mechanism:
- All systems of payment with control EXECUTIVE foresee a working in mode "price Holding".
ATTENTION:
The coin mechanisms must be bought complete with display, the standard machine is not fit with a
display.
9.1 MOUNTING THE COIN VALIDATOR FIG. 5
N.B.: All the mounting and the connections have to be carried out with machine off.
If you want to use only the coin validator it is necessary to have the interface card to mount inside the coin
mechanism. Remove the display mounting bracket and mount the display on the suitable stud bolts. Fix the
card on the side of the display using the already existent hole and making the three missing.
This card has to be connected to the connector on which the coin mechanism is generally connected, while
the validator has to be connected to the flat connector 16 circuits of the interface (ref. B fig. 5).
The coin validator has to be requested from the suppliers already mounted on the frame. This allows a
proper mechanical hooking to the machine and a correct directioning of the coins to the cash.
The interface card of the validator is complete with a display and it can be programmed through the selection
push-button panel of the machine.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
9

SYSTEMS OF PAYMENT

FIG. 5
17
E
N
G
L
I
S
H