Putting On An Taking Off The Helmet; Putting On The Helmet 94 K; Taking Off The Helmet - SCHUBERTH C3 Manual Del Usuario

E. PUTTING ON AND TAKING OFF THE
HELMET
1. PUTTING ON THE HELMET
Note:
See section D.9. for operation of the chin-strap / fastener system.
1. Open and lock the chin section. Make sure the sun visor is
retracted into the helmet shell.
2. Open the chinstrap and chinstrap comfort pad.
3. Take the lower ends of the chinstrap and pull these apart.
4. It will now be easy to put the helmet on.
5. Close the chinstrap comfort pad (with the Velcro fastener)
6. Fasten the chinstrap by pushing the ratchet tongue into the lock
so that you hear it engage properly.
7. Make sure the chinstrap passes under the chin and fi ts fi rmly.
8. Swing the chin section down until you hear both locks close and
the lock indicators in the chin section disappear.
9. Check that the chin section is securely locked by pressing it up
from below.
Note:
Regularly check that the chinstrap fi ts correctly and is adjusted
to the correct length (see section F.2.).
Caution:
Never ride with the chin section raised!
94

2. TAKING OFF THE HELMET

1. Open and lock the chin section. Make sure the sun visor is
retracted into the helmet shell.
2. Open the chinstrap by pulling the red strap on the ratchet
fastener and thus releasing the locking buckle. Having done this,
pull the ratchet tongue out of the locking buckle.
3. Undo the Velcro of the chinstrap comfort pad.
4. Grasp the ends of the chinstrap and pull the chinstrap ends apart.
5. The helmet can now be removed easily from the head.
6. Close the chin section.
Tip:
To avoid scratching any objects you might place the helmet on,
we recommend closing the chin-strap after you have taken the
helmet off.
95