Additional Safety Features 62 I; Reflective Panels; Putting The Helmet On And Taking It Off - SCHUBERTH C3 Manual De Uso

Ocultar thumbs Ver también para C3:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
C. THE HELMET
14. ADDITIONAL SAFETY FEATURES
ANTI-ROLL-OFF-SYSTEM (A.R.O.S.)
The Anti-Roll-Off system developed by SCHUBERTH is designed to ensure
that, with the chin strap done up and correctly adjusted,
a) the helmet cannot roll off the head
from behind,
b) contact between the chin section
of the helmet and the rider's chin or
throat is avoided thanks to the lower
angle of inclination,
c) the consequences of an impact to the
ribcage by the helmet in an accident
are reduced.

REFLECTIVE PANELS

To improve the visibility of the motorcyclist in road traffic, two reflective
areas are provided to the left and right under the visor pane and reflective
decals on the rear of the helmet.
Caution:
Keep the reflective safety areas clean.
62
D. PUTTING THE HELMET ON AND
TAKING IT OFF
Caution:
Check the correct positioning and length of the chin strap regularly.
1. PUTTING THE HELMET ON
1. Open the chin guard and lock in position. Ensure that the sun visor
inside the shell is lowered.
2. Open the chin strap.
3. Grasp the bottom ends of the chin strap and pull these apart.
4. Now you can pull the helmet easily onto your head.
5. Tighten the chin strap by inserting the ratcheting tongue gradually into
the locking mechanism until the strap sits firmly on your chin.
6. Ensure that the chin strap sits firmly under your chin.
7. Swivel the chin guard down until both locks engage audibly.
8. Check that the chin guard is locked in place by pushing upward from
below.
Warning:
Never ride with the chin bar raised!
EN
63

Publicidad

Tabla de contenido
loading

Tabla de contenido