Troubleshooting - Van Berkel International VOLANO Serie Manual Del Usuario

Troubleshooting

PROBLEM
Excessive resistance to cutting of
the product
The machine does not start when
the on button is pressed
Excessive resistance in motion of
the sliding components (product
holder, carriage)
REASON
The blade is dull
Lack of power or defective
control circuit
The lubrication of the
sliding guide may not be
sufficient
12
REMEDY
Sharpen the blade
Check that the plug has been
correctly inserted. If the machine
still does not start, contact the
service center
Carry out periodical lubrication as
described in this manual