Adjusting Dsp Modes - JVC TH-A30 Manual De Instrucciones

Creating Realistic Sound Fields
REW
VCR CHANNEL
B.SEARCH
2 3
TOP MENU MENU
1
4
7
SLOW
ANGLE ZOOM
REPEAT A-B REPEAT
CLEAR SEARCH
5
To adjust the output level for the center speaker,
the rear speakers, and the subwoofer
1) Press SOUND repeatedly to select the
"CEN," "REAR," or "SW."
• Each time you press the button, the adjustment
indication on the display changes as follows:
00 F 00
Normal indication
(canceled)
CEN (Center) : To adjust the output level for center
speaker (from –6 dB to +6 dB).
REAR : To adjust the output level for rear
speakers (from –6 dB to +6 dB).
SW (Subwoofer) : To adjust the output level for subwoofer
(from –6 dB to +6 dB).
• When selecting "3 STEREO," you cannot adjust the output
levels for the rear speakers.
• "CEN 0dB," "REAR 0dB," and "SW 0dB" are the initial
settings. If you have already changed the settings, another
value will appear.
2) Press 3 or 2 to adjust the
output level.
3 : Increases the output level.
2 : Decreases the output level.
3) Repeat 1) and 2) for setting
the other speakers.
25
FF
TUNING
F.SEARCH
ENTER
VOLUME
RETURN MUTING
SOUND
SOUND
2 3
SETTING
5 6
PRO LOGIC
8 9
SETUP TEST
0 DSP MODE
D.R.C DSP MODE
PROGRAM
REMAIN SLEEP
SOUND
00 R 00 CEN
SW
REAR
ENTER

Adjusting DSP Modes

You can adjust the following settings while activating DSP modes.
It is recommended that you make adjustments from your actual
listening point while listening to reproduced sounds.
– Output balance for the front speakers
– Output balance for the rear speakers
– Output level for the rear speakers*
– Output level for the subwoofer*
* The adjustment is separately memorized for DSP modes.
• DSP modes cannot be used with Dolby Surround. Once one of
DSP modes is activated, Dolby Surround in use will be canceled.
• When you play back a DVD encoded with Dolby Digital or DTS
Digital Surround, DSP MODE button (or DSP button on the center
unit) does not work.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Select and play any source except Dolby Digital
or DTS Digital Surround.
2
Press DSP MODE (or DSP on the front
panel) repeatedly to select the desired
DSP mode.
The DSP indicator lights up on the display while the DSP modes
are activated.
• Each time you press the button, DSP mode changes as follows:
THEATER
Normal
indication
(canceled)
Now, you are ready to start the adjustment.
• To adjust the output balance for the front speakers and the rear
speakers, go to the next step.
• To adjust the output level for the rear speakers and the subwoofer,
4
go to step on the next page.
DSP MODE
HALL LIVE CLUB
DANCE CLUB