Basic Tuner Operations; Turn On The Power; Select The Band; Adjust The Volume - JVC TH-A30 Manual De Instrucciones

Basic Tuner Operations

1
STANDBY/ON
AUDIO
STANDBY/ON
AUDIO
TV VCR
DISPLAY STEP
AUDIO/
SUBTITLE
FM MODE
2
FM/AM
DVD FM/AM
TUNER PRESET
DOWN
4
TUNING – REW
VCR CHANNEL
B.SEARCH
3
VOLUME –
TOP MENU MENU
• For in-depth information about tuner operations, see
"Tuner Operations" on pages 47 and 48.
• 10 kHz interval spacing is the initial setting for AM
tuner. You can change the interval spacing. See
"Setting the AM Tuner Interval Spacing" on page 47.
1

Turn On the Power

Press STANDBY/ON AUDIO (or
STANDBY/ON on the front panel).
The STANDBY lamp goes off and the
illumination lamp lights up on the center unit.
The source indication selected previously appears
on the display.
2

Select the Band

From the remote control:
Press FM/AM.
The last received station of the selected band is tuned in.
• Each time you press the button, the band alternates
between FM and AM.
On the front panel:
Press SOURCE repeatedly until the desired band (FM or AM)
appears on the display.
The last received station of the selected band is tuned in.
• Each time you press the button, the source changes as
follows:
DVD player*
AM
* "WAIT" appears on the display.
15
TV/VIDEO PROGRESSIVE
TV CHANNEL
TV VOLUME
VCR
AUX
CONTROL
UP
4
FF TUNING +
TUNING
F.SEARCH
ENTER
3
VOLUME +
VOLUME
MUTING
RETURN MUTING
STANDBY/ON
AUDIO
FM/AM
SOURCE
AUX IN
FM
3
A
djust the Volume
To increase the volume, press and hold VOLUME +.
To decrease the volume, press and hold VOLUME –.
VOLUME
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• By pressing VOLUME + or – repeatedly, you can adjust the volume
level step by step.
• The volume level can be adjusted within 51 steps—"MIN (minimum),"
01 to 49, and "MAX (maximum)."
• You can turn off the sounds temporarily by pressing MUTING.
4

Tune in to a Station

From the remote control:
Press and hold TUNING +
or – until the station
frequency starts changing
continuously on the display.
The system starts searching
for a station.
On the front panel:
1) Press 7 so that "MANUAL" appears on the display.
2) Press and hold ¢ or 4 until the station frequency starts
changing continuously on the display.
The system starts searching for a station.
Notes:
• When a station of sufficient signal strength is tuned in, the system
stops searching, and the
• When an FM stereo program is received, the
lights up.
• When you press the button repeatedly, the frequency changes step
by step.
To turn off the power (into standby)
Press STANDBY/ON AUDIO (or
STANDBY/ON on the front panel) again.
The illumination lamp goes off and the STANDBY
lamp lights up.
• A small amount of power is consumed even in
standby mode. To turn the power off completely, unplug the AC
power cord.
VCR CHANNEL
TUNING
B.SEARCH F.SEARCH
indicator lights up on the display.
indicator also
STANDBY/ON
AUDIO