Maintenance, Service, And Storage - DBI SALA Sealed-Blok Serie Instrucciones Específicas

unsafe or defective Conditions: If inspection reveals an unsafe or defective condition, remove the Sealed-Blok™ SRL
from service immediately and contact an authorized service center for repair.
note: Only Capital Safety or parties authorized in writing may make repairs to this equipment. (Excludes FAST-
Line procedure).
TM
i-SaFe™ RFid TaG: The Sealed-Blok™ SRL includes an i-Safe™ Radio Frequency Identification (RFID) tag. The
RFID tag can be used in conjunction with the i-Safe handheld reading device and web based portal to simplify
inspection and inventory control and provide records for your fall protection equipment. If you are a first-
time user, contact a Capital Safety Customer Service representative (see back cover); or if you have already
registered, go to www.capitalsafety.com/isafe.html. Follow the instructions provided with your i-Safe handheld
reader or on the web portal to transfer your data to your web log.
model
3400960, 3400961
3400943, 3400944
3400891, 3400892
3400996, 3400997
3400916, 3400917
3401008, 3401009

MaIntenanCe, servICe, and storaGe

• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so excess
water can drain out. Clean labels as required.
• Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat.
An excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing
causing a potential free fall hazard. Replace lifeline if excessive buildup is present.
• Additional maintenance and servicing procedures must be completed by an authorized service center.
Do not attempt to disassemble the SRL (excludes FAST-Line
5903076). NOTE: Do not lubricate any parts.
• Store SRL in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect the SRL after any period of extended storage.
Materials
Lifeline (Galvanized)
Lifeline (Stainless Steel)
Cable Guide
Housing
Cable Bumper
Housing Cover
Anchorage Handle
Fasteners
Main Shaft
Locking Pawls
Ratchet Center
Motor Spring
Finish Paint
Connecting Hook (Plated Steel)
Connecting Hook (Stainless Steel)
Figure 6 - i-Safe™ RFid TaG
Figure 7 - l x w x H / kg (lbs)
l x w x H / kg (lbs)
33.8 cm x 26.1 cm x 17.5 cm (13.3" x 10.3" x 6.9") / 14.5 Kg (32.0 lbs)
33.8 cm x 26.1 cm x 32.3 cm (13.3" x 10.3" x 12.7") / 17.2 Kg (38.0 lbs)
38.9 cm x 30.5 cm x 19.1 cm (15.3" x 12.0" x 7.5") / 27.7 Kg (50.0 lbs.)
42.3 cm x 35.8 cm x 21.6 cm (16.8" x 14.1" x 8.5") / 27.9 Kg (61.6 lbs.)
38.9 cm x 30.5 cm x 26.4 cm (15.3" x 12.0" x 10.4") / 25.0 Kg (55.2 lbs.)
42.3 cm x 35.8 cm x 29.7 cm (16.8" x 14.1" x 11.7") / 33.5 Kg (73.8 lbs.)
3/16in. dia., 7x19 aircraft wire rope, 4,200 lbs. (16.68 kN) minimum
tensile strength
3/16in. dia., 7x19 aircraft wire rope, 3,600 lbs. (16.01 kN) minimum
tensile strength
Nylon
Cast Aluminum
Urethane
Stainless Steel
Stainless Steel
Stainless Steel
Stainless Steel
Stainless Steel
Carbon Steel
Carbon Steel
Polyester Baked finish
Forged Alloy Steel
Stainless Steel
procedure; please refer to FAST-Line
TM
8
manual
TM