Repair And Warranty - Megger TDR2000 Manual De Instrucciones

The instrument contains static sensitive devices, and care must
be taken in handling the printed circuit board. If an instrument's
protection has been impaired it should not be used, but sent for
repair by suitably trained and qualified personnel.
The protection is likely to be impaired if for example; it shows
visible damage; fails to perform the intended measurements;
has been subjected to prolonged storage under unfavourable
conditions, or has been subjected to severe transport stresses.
NEW INSTRUMENTS ARE GUARANTEED FOR 3 YEARS
FROM THE DATE OF PURCHASE BY THE USER.
NOTE: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
INSTRUMENT REPAIR AND SPARE PARTS
For service requirements for MEGGER Instruments contact:
AVO INTERNATIONAL
Archcliffe Road
Dover
Kent, CT17 9EN.
England.
Tel: +44 (0) 1304 502243
Fax: +44 (0) 1304 207342
or an approved repair company.
16

Repair and Warranty

or AVO INTERNATIONAL
Valley Forge Corporate Centre
2621 Van Buren Avenue
Norristown, PA 19403
U.S.A.
Tel: +1 (610) 676-8579
Fax: +1 (610) 643-8625
Approved Repair Companies
A number of independent instrument repair companies have
been authorised for repair work on most MEGGER instruments,
using genuine MEGGER spare parts. Consult the Appointed
Distributor/Agent regarding spare parts, repair facilities, and
advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent freight pre-paid to the appropriate address. A
copy of the invoice and of the packing note should be sent
simultaneously by airmail to expedite clearance through
Customs. A repair estimate showing freight return and other
charges will be submitted to the sender, if required, before work
on the instrument commences.