R E PAIR AND W A R R A N T Y
The instrument contains static sensitive devices, and care must be taken in handling the
printed circuit board. If an instrument's protection has been impaired it should not be used, but
sent for repair by suitably trained and qualified personnel. The protection is likely to be
impaired if for example; it shows visible damage; fails to perform the intended measurements;
has been subjected to prolonged storage under unfavourable conditions, or has been
subjected to severe transport stresses.
NEW INSTRUMENTS ARE GUARANTEED FOR 3 YEAR FROM THE DATE OF
PURCHASE BYTHE USER.
N O T E :
Any unauthorized prior repair or adjustment will automatically invalidate the
Wa r r a n t y.
R E PAIR AND SPARE PA R T S
For service requirements for Megger Instruments contact:
Megger Limited
o r
M e g g e r
A r c h c l i ffe Road
Valley Forge Corporate Center
Dover Kent, CT17 9EN
2621 Van Buren Av e n u e
E n g l a n d
Norristown, PA 1 9 4 0 3
Tel: +44 (0) 1304 502243
U . S . A .
Fax: +44 (0) 1304 207342
Tel: +1 (610) 676-8579
Fax: +1 (610) 676-8625
20
Or an approved repair company. Approved Repair Companies
Anumber of independent instrument repair companies have been authorised for repair work
on most Megger instruments, using genuine Megger spare parts. Consult the A p p o i n t e d
Distributor/Agent regarding spare parts, repair facilities, and advice on the best course of
action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent freight pre-paid to
the appropriate address. A copy of the invoice and of the packing note should be sent
simultaneously by airmail to expedite clearance through Customs. Arepair estimate showing
freight return and other charges will be submitted to the sender, if required, before work on
the instrument commences.