System Information - Nussbaum BM 25 Instrucciones De Operación

Program display
Program ALU 1:
Impact weights are attached to the rim from the
exterior on both sides.
Program ALU 2:
Impact weights are attached to the rim from the
inside and are glued to the outside.
Program ALU 3:
Impact weights are attached to the rim from the
inside and are glued to the outside, as shown.
Auxiliary function „Placing behind the wire spo-
ke" (splitting) is possible.
Program ALU 5:
Weights are glued onto the rim on both levels.
Program ALU 6:
Weights are glued onto the rim on both levels.
Auxiliary function „Placing behind the wire spo-
ke" (splitting) is possible.
Program PAX 1:
Weights are glued on both levels in the shown
position. Wheel specification in millimeters.
Program PAX 2:
Weights are glued on both levels in the shown
position. Wheel specifications in millimeters.
Auxiliary function „Placing behind the wire spo-
ke" (splitting) is possible,
Static program:
A compensation weight is only attached on one
level. This program is used for balancing motor-
cycle wheels.
1 689 979 918N 13.01.2010
4.6

System information

Select the process counter via the start monitor and the F6 key.
The current software state (here, e.g. 1.02.20.03) is displayed at
the bottom of the monitor in the status strip.
33