Safety Notices; Safety Notices For The Operating Staff - Nussbaum BM 25 Instrucciones De Operación

2.

Safety notices

Please note the listed safety instructions are for your own safety
and for the safety of your customers. The safety instructions will
explain to you the possible dangers. At the same time, they
contain notices on how you can prevent dangers from occurring
by using the equipment properly.
Please see also Installation instructions 1 689 978 478N.
The safety instructions are also contained in the operating instruc-
tions. They are characterized by the following symbols:
i Information - contains a notice
! ! ! ! ! Caution - points out dangers for the test device/sample
Danger for persons - designated generally
2.1

Safety notices for the operating staff

i Please read and understand the accident prevention regu-
lations!
i
When the wheel balancer is not used, switch off the power
supply via the main switch. Secure the main switch against
unauthorized use.
i
Do not leave any wheels on the wheel balancer for a
prolonged period of time.
i
Working with the electrical system may only be executed
by trained electricians.
! The wheel guard should always be closed during the
balancing process.
When switching on the wheel balancer, wheels and
other objects must not be mounted on the main
shaft.
When operating the wheel balancer with an open
cover, other people should not be within the ma-
chine range!
Danger of life can exist for people around the
wheel area.
Repairs or other works must not be executed on
the wheel balancer if the machine has not been set
to the de-energized state (unplugged from mains).
The operational display of the wheel balancer is
shown on the monitor. In order to ensure that the
operating state (On/Off) can be detected at any
time; one must ensure under all circumstances
that the monitor is visible at all times.
1 689 979 918N 13.01.2010
The operating staff must wear working clothes
without loose strips and loops. This also includes
the work shoes without shoe laces.
Loose strips and shoe laces could get into the
wheel balancer and could endanger the operator.
The wheel must be mounted to the wheel balancer
with the corresponding clamping means.
The wheel balancer must be unplugged from the
main electricity supply before maintenance work
is executed.
Danger of electric shocks!
The electric system must be protected against
humidity and moisture.
Danger of electric shocks!
Do not carry out any set-up work while the inspec-
tion is being executed.
Danger of injuries!
25