jbc ADVANCED Serie Manual Del Usuario página 3

ENGLISH
SPECIFICATIONS
The station TE 5000 is used for desoldering and
soldering of small and medium sized SMD's by hot-
air.
- TE 5000 230V
- TE 5000 120V
TE 5000 can also be supplied without extractors
nor protectors:
- TE 5000 230V WE
- TE 5000 120V WE
The station's components
- Control unit with heater 200W
- TE 8600 heater stand
- Extractor stand
- Set of 5 protectors (Fig. 1, page 47)
- Set of 3 extractors (Fig. 2, page 47)
- 2 tripods for the protectors (Fig. 1, page 47)
- Set of 4 suction cups
- Suction tube with connectors
- 4 nozzles:
ø 2
ø 2,5
ø 3
ø 4
In order to make the nozzles removal easier, the
stand has a special bushing.(Fig. 3, page 47).
- Instruction manual
The pedal ref. 0964551 can be connected to the
connector placed at the rear of the station. This
article is not delivered with the station.
Control Unit technical specifications
- Temperature selection from 150 to 455°C (300 to
850°F).
- Accuracy of selected temperature: ±5%.
- Air flow regulation: 4-11 l/min.
- Station's maximum power: 225W.
- ESD protected housing.
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- Weight of complete unit: 11.2 kg (28 lbs).
Safety measures
-
-
-
Ref. 5000200
Ref. 5000100
-
-
Ref. 5010200
Ref. 5010100
Ref. 0798600
Ref. 0792800
Ref. 0930110
Ref. 0932330
Ref. 0990330
Ref. 0990350
Ref. 0990370
Ref. 0990410
Ref. 0795400
5 11
-10 Ohms/
2
Incorrect use of this tool may cause fire.
Be cautious when using the tool in places
where inflamable products are stored.
Heat can fire up inflamable products even
when they are not at sight.
Do not use when the atmosphere is explosive.
Place the tool back on its stand in order to let
it cool down before you store it.