Danger Of Injury; Risk Of Injury; Eu Declaration Of Conformity; Opening/Closing The Lock - Kärcher MC 250 Implementos

Apply parking brake.
CAUTION

Danger of injury

Switch off the suction fan before emptying the waste con-
tainer.
CAUTION

Risk of injury

During the emptying process, persons and animals must
not abide within the swivelling range of the waste contain-
er.
CAUTION
Crush hazard
Never reach into the rod assembly for the emptying mech-
anism.
CAUTION
Risk of fire
When emptying, make sure that no flammable material
(e.g. leaves ... ) is present in the emptying area.
Emptying the waste container
1
Manual suction hose attachment kit (optional)
2
1. If a manual suction hose attachment kit is attached to
the vehicle, fold it to the side and secure it before emp-
tying. See chapter "Manual suction hose attachment".
2. Drive the vehicle to the emptying position in slow trans-
port mode.
3. Stop the vehicle.
4. Bring the travel direction lever into the neutral position
(middle position).
5. Switch on the hydraulic system (PTO).
Lift/empty waste container switch setting
1
Lower waste container switch setting
2
6. Operate the switch.
24
7. Empty the waste container.
Note
Always raise the waste container fully to the end posi-
tion.
If necessary, remove any adhering soiling with a dirt
scraper (optional) and clean with water. See chapter
"Cleaning the waste container"

1.1.4 EU Declaration of Conformity

We hereby declare that the machine described below com-
plies with the relevant basic safety and health require-
ments in the EU Directives, both in its basic design and
construction as well as in the version placed in circulation
by us. This declaration is invalidated by any changes made
to the machine that are not approved by us.
Product: Sweeper
Type: PF-E (MC 250)
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2000/14/EC
Harmonised standards used
EN 13019
CISPR 12
Applied conformity evaluation method
2000/14/EG: Appendix V
Sound power level dB(A)
MC 250 Euro 6
Measured: 106
Guaranteed: 108
MC 250 Stufe V
Measured: 105
Guaranteed: 108
The signatories act on behalf of and with the authority of
the company management.
H. Jenner
Chairman of the Board of Management
Documentation supervisor: S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2020/01/01
1.2

Opening/closing the lock

The locks secure the attachment devices (e.g. sweeping
system). These are located on the left and right sides in the
area in front of the front wheel and are recognizable as yel-
low levers.
CAUTION
Danger of accident
Check the locking mechanism for correct adjustment with
each attachment.
English
S. Reiser
Director Regulatory Affairs & Certification