Storage; 3-Brush Sweeping System Attachment (Ex Works); Requirements For Removal/Installation; 3-Brush Sweeping System Device View - Kärcher MC 250 Implementos

Screw 1
1
Screw 2
2
2. Unscrew the screws.
3. Adjust the side inclination via the rotation point of screw
1.
4. Tighten the screws.
Adjusting the head inclination forwards
Lock nut
1
Hexagon head
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pres-
sure relief system.

1.3.8 Storage

WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place.
Ensure that the sweeping brushes are not loaded.
1. Remove the sweeping system from the vehicle, then re-
move the sweeping brushes and store the sweeping
system on the pallet.
2. Ensure that the sweeping brushes are not loaded during
attachment to the vehicle.
1.4 3-brush sweeping system attachment (ex
works)

1.4.1 Requirements for removal/installation

A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.
28

1.4.2 3-brush sweeping system device view

Front brush
1
Front brush arm
2
2-brush sweeping system
3
Slide
4

1.4.3 Removing the 3-brush sweeping system

 Removal of the sweeping system is described using the
optionally available changing carriage.
Symbolic figure: The 2-brush sweeping system with the
changing carriage is shown here
Holder for hydraulic hose couplings on the changing
1
carriage
Lift truck
2
Hydraulic hose couplings on the vehicle
3
Side brush holder
4
Side brushes
5
1. Stop the vehicle on level, solid ground and secure it
against rolling away.
2. Use a lift truck to move the changing carriage into posi-
tion under the vehicle.
3. Insert the side brushes individually into the side brush
holder and lower them into the correct position.
4. Depressurise the front hydraulic system. See chapter
"Depressurizing the hydraulic system".
5. Disconnect the hydraulic hoses, water connections and
power supply and stow them in the holder on the chang-
ing carriage.
6. Loosen the suction hose at the suction mouth (hose
clip).
7. Loosen the carrier connection between the vehicle and
the suction mouth (left / right).
8. Open the locks (left and right). See chapter "Opening /
closing the lock".
English