2-Brush Sweeping System Attachment (Ex Works); Requirements For Removal/Installation; View Of The Device For A 2-Brush Sweeping System; Removing The 2-Brush Sweeping System - Kärcher MC 250 Implementos

Screw (18 mm)
1
Yellow locking level
2
Handle
3
Mounting arm from attachment
4
Opening the lock
1. Loosen the screws from the left and right locking levers
by approx. 1 cm.
The lock is released.
2. Lift the locking lever on the side handle, then push it
back. The attachment can be attached.
Locking the lock
3. Insert the mounting arm from the attachment all the way
to the end stop.
4. Push the locking lever forwards.
5. Tighten the screw, check that the attachment is securely
attached.
1.3 2-brush sweeping system attachment (ex
works)

1.3.1 Requirements for removal/installation

A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.
1.3.2 View of the device for a 2-brush sweeping
system
Figure: Sweeping system attached
2-brush sweeping system with suction mouth
1
Side brushes
2
Water connection
3
Hydraulic connection
4
Attachments power supply
5

1.3.3 Removing the 2-brush sweeping system

 Removal of the sweeping system is described using the
optionally available changing carriage.
Figure: Sweeping system with changing carriage
Holder for hydraulic hose couplings on the changing
1
carriage
Lift truck
2
Hydraulic hose couplings on the vehicle
3
Side brush holder
4
Side brushes
5
1. Stop the vehicle on level, solid ground and secure it
against rolling away.
2. Use a lift truck to move the changing carriage into posi-
tion under the vehicle.
3. Insert the side brushes individually into the side brush
holder and lower them into the correct position.
4. Depressurise the front hydraulic system. See chapter
"Depressurizing the hydraulic system".
5. Disconnect the hydraulic hoses, water connections and
power supply and stow them in the holder on the chang-
ing carriage.
6. Loosen the suction hose at the suction mouth (hose
clip).
7. Loosen the carrier connection between the vehicle and
the suction mouth (left / right).
8. Open the locks (left and right). See chapter "Opening /
closing the lock".
9. Extend the changing carriage together with the 2-brush
system (without suction mouth).
10.Raise and secure the waste container.
English 25