Sweeping Mode; Symbols On The Display During Sweeping; Fill The Fresh Water Tank / Recycling Water Tank; Working With Spray Water - Kärcher MC 250 Implementos

1.5

Sweeping mode

1.5.1 Symbols on the display during sweeping

The following symbols and warning indicators are also
shown on the display during sweeping.
Suction mouth is down (lowered)
Suction mouth camera activated
The waste container is raised

1.5.2 Fill the fresh water tank / recycling water tank

Left side panel
1
Filler neck with cover
2
Fresh water tank cap
3
Manual suction hose flap/overflow protection
4
Note
The open flap of the manual suction hose provides over-
flow protection when filling
1. Swing the left side panel outwards.
2. Remove the cover from the filler neck and attach a suit-
able water supply hose.
3. Unscrew the fresh water tank cap.
4. -Open the manual suction hose flap
Filler neck with cover
1
32
Switchover valve position for filling the recycling water
2
tank
Switchover valve position for filling the fresh water tank
3
5. Select the position of the switchover valve accordingly.
Fill the fresh water tank or recycling water tank.
a Maximum fresh water tank filling quantity: 190 litres
b Maximum recycling water tank filling quantity: 445 li-
tres
6. Fit the cover again after filling.

1.5.3 Working with spray water

 Working with fresh water
The dosing buttons for the spray water are located next to
the steering wheel.
Fresh water pump switch
1
Left side brush spray water dosage knob
2
Right side brush spray water dosage knob
3
Suction mouth spray water dosage knob
4
(1)Switch on the fresh water pump via the switch on the
armrest control panel.
(2)Turn the appropriate dosing buttons to dose the amount
of water.
More water: Turn anti-clockwise.
Less water: Turn clockwise.
English