Transport Lock; Care Work; Adjusting The Sweeping Area; Storage - Kärcher MC 250 Implementos

1.4.7 Transport lock

The front brush must be secured when driving on public
roads (transport journeys).
Bolt
1
Spring pin
2
1. Move the front brush carriage all the way to the left.
2. Secure the front brush in the corresponding position us-
ing a pin and spring pin.

1.4.8 Care work

ATTENTION
Malfunction or risk of damage
Do not grease, oil or grease the guides on the carriage.
1 The existing lubrication points (grease nipples) are la-
belled.
Lubricate daily with multi-purpose grease.
2 Check the front brush and sweeping brush for tangled
cords and straps and remove as necessary.
3 Keep the hydraulic connections clean and check for
leaks once a week.
4 Check the front brush and sweeping brush for wear and
tear and replace if necessary.

1.4.9 Adjusting the sweeping area

1. Adjust the sweeping area as shown in the illustration.
Right: 9 am- 2 pm
Right-hand side: 10 am- 3 pm
Adjusting the side inclination
Screw 1
1
Screw 2
2
2. Unscrew the screws.
3. Adjust the side inclination via the rotation point of screw
1.
4. Tighten the screws.
Adjusting the head inclination forwards
Lock nut
1
Hexagon
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pres-
sure adjustment system.

1.4.10Storage

WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place.
Ensure that the sweeping brushes are not loaded.
1. Remove the sweeping system from the vehicle, then re-
move the sweeping brushes and store the sweeping
system on the pallet.
2. Ensure that the sweeping brushes are not loaded during
attachment to the vehicle.
English 31