Fcc Compliance Statement; Industry Canada Statement - DSC 3G2060 Manual Del Usuario

FCC Compliance Statement

CAUTION: Changes or modifications not expressly approved by the Digital Security
Controls could void your authority to use this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Re-orient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: 'How to Identify and
Resolve Radio/Television Interference Problems'. This booklet is available from the U.S. Gov-
ernment Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.
T
W :
ARNING O SATISFY
,
TING DEVICES A SEPARATION DISTANCE OF
BETWEEN THE ANTENNA OF THIS DEVICE AND PERSONS DURING DEVICE OPERATION

Industry Canada Statement

The prefix 'IC:' in front of the radio certification number signifies only that Industry Canada
technical specifications were met.
Certification Number IC: 160A-3G260R
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is sub-
ject to the following tow conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Le
fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter toute interférence, y compris les interferences qui
peuvent causer un mauvais fonctionnement de l'appareil.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
© 2012 Tyco International Ltd. y sus compañías respectivas. Todos los derechos reservados.
Toronto, Canadá · www.dsc.com
Soporte técnico: 1-800-387-3630 (CA, US), 905-760-3000
Impreso en Canadá
FCC RF
EXPOSURE REQUIREMENTS FOR MOBILE TRANSMIT-
20
CM OR MORE MUST BE MAINTAINED
2 9 0 0 8 3 0 5 R 0 0 1
.