f. The helmeT
Tip:
The sun visor holders should remain in the lower position until you
re-fit the visor.
Fitting the sun visor
1. Put the sun visor between the snap
connections and fit it onto the
retaining pegs on one side and then
on the other.
2. Position the sun visor between
helmet inner and outer shell and
retract it with the operating slide.
3. To be on the safe side, check
that the sun visor mechanism is
functioning correctly.
Warning:
Riding without the faceshield or with an open faceshield can result
in injury to the eyes and face through stones, dust, insects and
other flying objects. The sun visor, when lowered, will provide a
certain amount of protection from light impact from stones or
insects but cannot protect from all hazards.
Note:
For cleaning instructions see section I.3. (maintenance and
care– Faceshield and sun visor) of this manual.
40
11. INTERIOR LINING
The exchangeable interior lining of the C3
both an excellent fit as well as enhanced ventilation of the helmet.
The high-comfort cheek pads ensure that the helmet fits comfortably
around the cheeks and the crown lining makes for an optimal fit right
around the head. The head pad sits comfortably on the head without
covering the ventilation channels (see Section F.12., Ventilation
systems – Head ventilation).
All parts of the interior lining are made from materials that are
gentle on the skin (especially those that come into direct contact
with the head). The material predominantly used is Coolmax
soft, breathable material that also transports warmth and moisture
very well. The head pads are produced from a special, antibacterial,
perspiration-absorbing material.
Removing and fitting the Crown Lining
The crown lining is attached to the inner shell by means of Velcro
strips and clamp fittings, and can be removed by careful pulling it out.
The plastic strip sewn into the front section and the clips in the neck
zone allow the crown liner to snap into place securely.
1. Slide the plastic strip piece by piece
under the notches of the plastic strip
attached to the inner shell.
is washable and ensures
®
, a
®
41