Interior Lining - SCHUBERTH J1 Manual Del Usuario

D. THE HELMET
Fitting the sun visor
1. Position the sun visor holders on the helmet (on the left with the
sun visor slide) so that you can see the mounting sockets for the
sun visor.
2. Carefully insert one end of the sun visor (with snap connector) into
the corresponding mounting socket of the helmet, then push with
appropriate pressure so that you feel and hear it snap in place.
Repeat this with the other side.
3. Retract the sun visor between helmet outer and inner shell and
lower it with the operating slide.
4. Check that sun visor mechanism is operating correctly.
Tip:
The sun visor was developed so that it can also be fitted with the
straight edge at the bottom. Since one person's vision differs
from another, this adaption can be more practical and
comfortable for your own sense of vision.
74

12. INTERIOR LINING

The two-colour, exchangeable interior lining of the J1 guarantees both
an excellent fit (through the MaxFit
ventilation. The headband padding ensures that the helmet fits
comfortably all around the head; there are three colour-contrasted
head pads that cushion the head without covering the ventilation ducts
(see also Section D.13. "Ventilation systems – head ventilation").
The interior lining is made of materials that are kind to the skin
(especially where there is direct contact with the head). The principal
material used is soft, breathable, perspiration-absorbing soft velour.
The head pads are made from a special anti-bacterial, moisture-
absorbing material. Moreover, the J1 is provided with a large
proportion of TechSkin – a specially developed comfort material with
a high-quality, leather-like surface structure.
Rem ovi ng and fit t i ng
Headband and pads are fixed to the inner shell with Velcro and can
be removed by careful pulling. Make sure the headband is positioned
centrally when re-fitting it. To help you with this, the headband has
two flattened areas at the back end of the headband. Position the
headband in the inner shell so that the two flattened areas each lie on
a line with the two interior ventilation channels.
® interior concept) and a better
75