Hologic FLUENT FLT-100 Manual Del Operador página 46

Item
Dimensions (Width x Height x Depth)
Weight
Mass
Safe Working Mass
Interfaces
Signal IN/OUT components
Mains connection
Maximum Load Cell Capacity
System Useful Life
Power Cord Safety
Ensure the connection data and technical specifications of the power supply comply with DIN VDE or national requirements. The wall outlet
power supply cord must be plugged into a properly installed safety wall plug (see DIN VDE 0107). Read the device label located in rear of pump to
determine the operating voltage of the system.
The power connection must be equipped with a grounding contact. Use the Fluent Fluid Management System power cord to establish a
connection between the wall outlet and the power cord connection located in the rear of the system.
Only for U.S. operators: Use only a certified (UL-listed), removable power cord, type SJT, minimal 18 AWG, 3 leads. The plug connectors must
comply with NEMA 5-15 or IEC 320/CEE22. Grounding will only be reliable if the equipment is connected to a corresponding hospital grade outlet.
Integrate the system into the potential equalization system as specified by local safety rules and regulations.
Medical devices are subject to special safety and protective measures concerning electromagnetic compatibility (hereafter abbreviated as EMC).
This system is to be used only for the purposes described in the manual and has to be installed, set up, and operated in compliance with the EMC
notes and instructions. See Chapter 13: Electromagnetic Compatibility.
44
Fluent Fluid Management System
Specification
25in x 60in x 25in / 250mm x 600 x 250mm
Unpacked console 40kg
40Kg
44.5Kg
None
IEC-60320-1 C14
<6.3Kg for Supply and Waste bag hooks
The system shall have a useful life up to 1,000 hr
Chapter 12: Technical Specifications English