Startup - Ega Master 79613 Manual De Instrucciones

Connecting the air supply to the pneumatic impact wrench
Remove the locking cap from the connection 3 (see fig. 2) at the air inlet.
Screw a hose nipple, e. g. for quick-release coupling (not contained in the scope of delivery),
into the connection 3 at the air inlet.
The pneumatic impact wrench works optimally at an operating pressure of 6(4) bar, measured
at the air inlet when the pneumatic impact wrench is on. When connecting the machine, pay
attention that the valve trigger 1 (see fig. 3) is not actuated.
Blow out the pneumatic hose bevor connecting the machine. Never connect a pneumatic hose
being under pressure (see safety instructions for prevention of hazards caused by compressed air).
First connect the machine and then connect the compressed air supply.
Prior to starting the machine put the reverse slide for rotation direction left and right into the
correct position. For example, if you want to loosen a screw and the rotation direction is adjusted
to a position for screwing in, this can lead to violent uncontrolled movement of the pneumatic
impact wrench.
Setting the rotation direction
The rotation direction is set with the reverse slide 2 (see fig. 4).
Actuate the reverse slide only when the pneumatic impact wrench is switched off.
Rotation direction right: For screwing-in of screws and nuts turn the reverse slide clockwise.
Rotation direction left: For unscrewing of screws and nuts turn the reverse slide anticlockwise.
Put the power socket wrench solidly and correctly on the screw head or the nut and start the
pneumatic impact wrench. (fig. 5)
Fig. 3

STARTUP

31