Ega Master 79613 Manual De Instrucciones página 32

Start and stop
Insert tool
Slide the tool over the drive square 7 of the tool holder.
Pay attention that the circlip locks in the groove of the tool. Only use tools with suitable shank
(see "Technical Specification").
Remove tool
Pull the tool from the tool holder. Stucking tools can be loosened by slight beats with a rubber
hammer.
Change tools
When inserting a tool, pay attention that it is properly seated on the tool holder.
If the tool is not firmly fixed to the tool holder, it can unscrew and cannot be controlled
anymore.
Before each operation, make visual check of the machine and machine tools, as well as
accessories with regard to integrity and appropriateness for the application.
Never operate the machine if one or more parts (e. g. machine tools, cables, lines) are damaged,
if it is not working properly, if any damages can be identified or are to be suspected (e. g. after it
has been dropped).
Replace damaged parts immediately.
Never remove protective devices from the machines where fitted.
Ensure they are in good condition and properly adjusted before starting the machine. A
malfunction, which impairs operator safety, must be immediately removed.
Pay attention that the machine is cleaned from dust and deposits of rust particles and other
deposits before and after the work.
32
Fig. 5 Press or release
Fig. 6