Ega Master 79613 Manual De Instrucciones página 41

WARNING – Danger of explosion! Generation of sparks during maintenance
work!
Observe local safety regulations. Avoid use of force when disassembling and
assembling the machine. Always do maintenance work outside areas which are
not exposed to explosion hazards.
PROHIBITION –
Eating, drinking and smoking are forbidden during maintenance and repair
work.
NOTICE – Only use original the manufacturer service tools, in order to avoid
damages. Check the adherence to the technical specifications according to the
operation manual after each maintenance work. Only use genuine spare parts.
Otherwise you risk a decrease in machine performance and an increase in
maintenance work.
IMPORTANT – There is no warranty for damages and liability is disclaimed, if
non-original spare parts are used.
Maintenance Instruction
Generally, pneumatic machines need little maintenance. If the following rules are observed, the
machine will have the expected long life-time and high reliability. Service life and performance of
the machines are decisively determined by:
• The air purity
• The lubrication conditions and maintenance
• The regular control of the compressed air filter, as well as the regular checking of the
machine with regards to external damages.
Inspection and maintenance can be done by the operator. Disassembly and re-assembly of the
machine have to be executed by qualified staff only. Incorrect assembly can lead to danger of
accident for the operator and to defects on the machine.
As already mentioned, the maintenance of the pneumatic drive has to be done by using a
maintenance unit, respectively by lubricating the air connection. Furthermore, it is compulsory to
check, if there is enough grease in the impact mechanism and to refill or change it, if necessary.
Impact mechanisms, which are not properly greased, wear out earlier, have a decrease in
performance and normally stop working after a certain period without lubrication.
After completing maintenance and repair work and before restarting production make sure that...
• All materials, tools and other equipment which are required for maintenance or repairs have
been removed from the work area of the machine.
41