SICK IN4000 Direct Manual Del Usuario página 120

3
Chapter
120
© SICK AG • Industrial Safety Systems • Germany • All rights reserved 8012183/2008-02-01
Mounting
The safety sensor is supplied pre-assembled on a
mounting bracket. It is not necessary to dismantle the
mounting bracket to align the sensing face on the
sensor.
Align the sensing face on the safety sensor such that it
is orientated towards the moving part of the guard
(door or similar); for this purpose if necessary
undo the hex socket head screw on the sensor
bracket and pull the sensor off the bracket (cf.
Fig. 4 a-b)
undo the two screws on the bottom corner of the
sensor housing and rotate the sensing face on the
sensor to the correct position (cf.
Fig. 4 c-d)
refit sensor housing and refit the sensor to the
sensor bracket (cf. Fig. 4 e-f)
Operating Instructions
IN4000 Direct