Commissioning And Operation; Tests Before The Initial Commissioning; Checking Start Function - SICK IN4000 Direct Manual Del Usuario

Ocultar thumbs Ver también para IN4000 Direct:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5
Chapter
5
WARNING
WARNING
126
© SICK AG • Industrial Safety Systems • Germany • All rights reserved 8012183/2008-02-01

Commissioning and operation

Commissioning and operation
Prior to initial commissioning, the machine or system
safety functions must be fully checked by specialist
personnel and also documented.
After every change and after maintenance and repair
work, the entire protective device must be checked
for effectiveness by specialist personnel.
5.1
Tests before the initial
commissioning
Check observance of the conditions as per
chapter 3.
Perform electrical function test on the sensor
together with an appropriate evaluation unit or a
safe control.
5.1.1

Checking start function

The check must be performed separately for each
protective device.
Deactivate the machine or the system
Open the protective device
Start the machine or system; if the safety function of
the protective device is correct, the machine or system
must not start.
If, nevertheless, the machine or system starts, again
check compliance with mounting conditions, the
correctness of all electrical connections and correct
the function of the safety system.
Operating Instructions
IN4000 Direct

Publicidad

Tabla de contenido
loading

Tabla de contenido