Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
You can return to timer programming mode by pressing the time button (11) to check the time remaining until
switch-off or to change the current settings.
The timer can be programmed only with the burner in operation. Countdown starts immediately after burner
ignition. When the countdown is over, the programmed burner will go out and give a series of sound signals
for 30 seconds (you can turn the sound signals off by pressing the clock button (11)).
If the programmed burner is put out by user, the corresponding timer is switched off.
Programming simultaneous switch-off time for several burners
You can program switch-off time for several burners that operate simultaneously. The initial step is identical
to the above-mentioned single burner programming. To complete programming operation: press the clock
button (11) and move on to the next burner (no confirmation of programmed data is required). If another
burner needs to be programmed, you must confirm it by pressing the clock button.
Clock adjustment
In case of power supply failure, you must set the time displayed by the cooktop internal clock. To set the
clock, switch on the cooktop by pressing the "ON/OFF" button. Then simultaneously press buttons 14 and 11
and hold them for at least 3 seconds.
The flashing number to the left of the point indicates hours, the number on the right indicates minutes. You
can increase or decrease hours value by pressing buttons 12 and 13. If you press and hold buttons 12 and
13, you can change the hours value successively.
To set minutes, press the clock button (11) one more time. Numbers to the right of the point will start flashing.
You can set the minutes value in the same way as the hours value.
To save the set time, press the clock button (11).
Releasing burner lock (Fig. 14)
If a burner is locked, letter "b" will be indicated on the corresponding display. To release the lock,
simultaneously press buttons 1 and 14 (for 90 cm) or buttons 3 and 14 (for 60 cm) and hold them for at least
2 seconds. After the lock is released, burners are set to level 0 and are ready to be switched on.
NOTE: if the lock release process is repeated 5 times within 15 minutes, the appliance will indicate signal
FLT06 and will not accept lock release commands for the next 15 minutes.
Child lock function
Can be activated only if the cooktop is off. To activate, press button 14 and hold it for at least 3 seconds. After
the key lock is activated, all keys are turned off. In this case decimal points are indicated on each burner
power level display.
To deactivate this function, press button 14 one more time and hold it for at least 3 seconds (all decimal points
on power level displays will go out when the key lock is released).
Key lock release
To release key lock, press button 14 and hold it for at least 2 seconds. All decimal points on flame level
displays will disappear when key lock is released.
RELEASING BURNER LOCK "b"
FIG. 14
7
Publicidad
Tabla de contenido
