Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Before
attempting
disconnect the appliance from gas mains and
electrical mains.
INSTALLATION TIPS
•
The appliance is designed to work continuously for
not more than 24 h (non-continuous operation
system). When this time goes out, an adjustment
break begins. During this break the appliance will
check its performance efficiency.
•
This automatic appliance is a safety-related device;
its
design
modifications
Modifications to this appliance design relieve the
manufacturer from any liability whatsoever and
cancel the warranty.
•
The appliance conforms to all applicable national
and European standards (such as EN 60335-1/EN
60335-2-102) in the field of electrical safety.
•
Before starting to use the cooktop, carefully check
the cables: a non-conforming cable can damage the
appliance and put the system safety at risk.
•
Turn the cooktop on and off only after the power
supply is connected.
•
Do not let water droplets end up on the appliance.
MAINTENANCE
any
maintenance
are
prohibited.
work
•
Make sure that valve cables are not located near
the high voltage cables of ignition transformer.
•
Before switching on make sure that there are no
foreign objects on the cooktop, particularly, in the
control panel area.
•
After the cooktop is turned on, wait for a few
seconds for the process of control panel automatic
calibration to be completed.
In case of "partial" short circuit or insufficient
•
insulation between line and earthing, voltage on
the sensor electrode may drop to a level when
appliance interlock is initiated, because it is not
possible to accept the ignition signal.
•
Touching the extra-low voltage (ELV) circuit is
dangerous (only basic insulation as per EN
60730-1 is provided). Therefore, the appliance
must ensure a level of electrical discharge
protection for the user interface that is equivalent
to double insulation.
23
Publicidad
Tabla de contenido
