Pando PGA-4490 Instrucciones Y Consejos Para El Uso, La Instalación Y El Mantenimiento página 114

ADJUSTMENT AND MODIFICATION WORK
Before starting any adjustment work disconnect the appliance from electrical power.
After adjustment or pre-adjustment is completed, all lead seals that could be taken off in the process,
must be restored by the technician.
9) MINIMUM BURNER POWER ADJUSTMENT PROCEDURE. (Fig. 15)
Minimum power setting procedure allows to modify the programmed minimum power and adjust each burner
according to the characteristics of the gas supply mains which the cooktop is connected to.
After switching on the cooktop, begin the procedure by pressing the "+" and "-" buttons of burner 3 simultaneously
with the "+" and "-" buttons of burner 1 (for 5F) or the "+" and "-" buttons of burner 5 (for 4F), and hold them for 3
seconds. All other burners must be switched off (in standby mode).
When the adjustment procedure has been initiated, "MIN" will be shown on the display. In this time, you can select
the burner to be adjusted using buttons 12 and 13 ("-" and "+" in clock programming). After confirming with the
clock button (11), the selected burner will ignite at minimum power. You can increase or decrease the power to
minimum level using the "+" and "-" buttons of the burner. During adjustment procedure, flame power levels on the
display will be indicated if the programmed minimum level matches factory settings. Flashing indication will change
, showing a higher or lower power than the programmed power.
To confirm the minimum power selected, press the clock button (11). "MIN" will continue to be shown, but none of
the displays will be flashing. At this time, you can press the clock button (11) to exit the adjustment procedure, or
press buttons 12 and 13 to select another burner and program its minimum power. The appliance will accept and
store the minimum power levels and will use them during regular cooktop operation (see Fig. 11).
Gas type selection (Fig. 16)
The cooktop can be set to operation with methane or liquefied petroleum gas. Before starting gas selection
procedure, the cooktop must be in operation, and all burners must be switched on. Simply press the "-" buttons of
burner 5 and burner 1 simultaneously with button 12 (for 90 cm), or the "-" buttons of burner 5 and burner 2
simultaneously with button 12 (for 60 cm) and hold them for at least 2 seconds. After the gas selection procedure
has been started, burner power level displays will go off, and "nAt" or "LPG" will be shown on the timer display,
depending on the set configuration. You can select the desired setting using buttons 12 and 13. To complete the
procedure, user must press the clock button (11).
Activating this function results in reset of switch-off time programmed for burners (see Fig. 11).
THE BURNERS DO NOT REQUIRE PRIMARY AIR ADJUSTMENT.
18