Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3) COOKTOP BUILDING-IN
Remove external packaging and internal packagings
of all movable components. Make sure that the
cooktop is in good working condition. If there are
doubts as far as appliance condition is concerned,
using the appliance is prohibited. Please contact
qualified personnel.
Keep packaging elements (cardboard, bags,
foamed polystyrene, nails ...) away from children
as they are a potential hazard source.
To build the cooktop in, cut out an opening in the load-
bearing furniture table
in Fig.6. Make sure that you strictly follow the limit
distances in the area of appliance installation (see
Fig. 7).
The equipment is a class 3 product. Therefore, it
must comply with all the requirements specified
in standards applicable to this product.
The appliance may be installed only with one side wall
(on the right or left of the cooktop). This wall must be
higher than the cooktop level and must be positioned
with respect to the minimum distance indicated in the
table given below.
Warning: the edge of glass section (A) must not
rest on the panel or worktop. It should support
the edge of metal section (B) that must be
touching the cooktop (see Fig. A).
It is important to take into account the cut-in
dimensions.
E
FIG. 9
INSTALLATION
top with the dimensions given
-
A
4) COOKTOP FIXING
The cooktop is fitted with a special gasket that
prevents any ingress of liquid inside furniture. To
correctly install this gasket, it is recommended to
strictly follow the below instructions:
Remove all movable parts of the cooktop.
-
Cut the gasket into 4 parts of appropriate length in
-
order to install them on 4 edges of the glass top.
Turn the cooktop over, correctly position the
-
adhesive surface of gasket E (Fig. 8) under the
cooktop edge, so that the outside gasket edge is
precisely aligned with the cooktop perimeter edge.
Outside band edges must be aligned without
overlapping.
Pressing with your fingers, attach the gasket to
-
glass evenly and reliably.
Install the cooktop into the opening made in the
-
furniture and fix it using screws F, by means of fixing
hooks G (see Fig. 9).
To prevent potential accidental contact with cooktop
-
surface that becomes very hot during operation, a
wooden pad must be installed at the distance of at
least 70 mm from the tabletop, and fixed using
screws (Fig. 6).
To fix this appliance on the load-bearing structure,
-
we recommend to avoid using mechanical or
electrical screwdrivers. Instead, tighten the fixing
hooks by hand, with medium force.
B
FIG. A
14
F
FIG. 10
G
Publicidad
Tabla de contenido
