Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENT AND MODIFICATION WORK
Display of temperature inside the cooktop
The electronic board features a temperature sensor that allows monitoring temperature inside the cooktop
directly on the timer display. To switch on this indication, press the "+" and "-" buttons of burner 1
simultaneously with buttons 12 and 13 (for 90 cm), the "+" and "-" buttons of burner 5 simultaneously with
buttons 12 and 13 (for 60 cm) and hold them for at least 3 seconds. At this time using clock 11 for settings
related to burner switch-off time programming, will be impossible.
To switch off internal temperature indication, press the buttons in the same order as for switching on.
Electronic self-test
Electronic boards continuously monitor their status. If hardware problems or faults occur inside the electronic
board, including to the extent that may be dangerous for the end user, the appliance enters into "safe" state.
In this state, the solenoids are switched off, and a code is shown on the display indicated the type of fault.
Limit exceeded for 5 attempts to release lock
Fault type
One burner locked
Uncontrolled flame / flame sensor circuit
failure on one burner
Main valve circuit failure
Voltage failure in reference circuit
Protection circuit failure
Microcontroller ports failure
EPROM failure
Valve control circuit failure
within 15 minutes
Power supply circuit failure
Sound alarm failure/ general failure
All burners locked
Logic control communication failure
Control panel control failure
Displayed error
code
Flt00
Flt01
Flt02
Flt03
Flt04
Flt05
Flt06
Flt08
Flt09
Flt0A
Flt0[
Flt0E
21
B
F
Publicidad
Tabla de contenido
