Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL INFORMATION FOR INSTALLATION
PERSONNEL
Installation,
adjustment,
maintenance described in this chapter can be
performed only by qualified personnel.
The equipment must be correctly installed in
compliance
with
manufacturer's requirements.
The manufacturer cannot be held liable for damage
to people, animals or property resulting from
incorrect installation of the appliance.
Modifications of devices that ensure equipment
safety or automatic regulation can be made only by
the manufacturer or its verified supplier throughout
the entire service life.
INSTALLATION TIPS
•
The appliance is designed to work continuously for
not more than 24 h (continuous operation system).
When this time goes out, an adjustment break
begins. During this break the appliance will check its
performance efficiency.
•
This automatic appliance is a safety-related device;
its design modifications are prohibited. Modifications
to this appliance design relieve the manufacturer
from any liability whatsoever and cancel the
warranty.
•
The appliance conforms to all applicable national
and European standards (such as EN 60335-1/EN
60335-2-102) in the field of electrical safety.
DIMENSIONS TO BE FOLLOWED
(in mm from cut-out)
A
5F (90)
833
INSTALLATION
modification
valid
regulations
B
C
D
483
62.5
62.5
•
Before starting to use the cooktop, carefully check the
cables: a non-conforming cable can damage the
and
appliance and put the system safety at risk.
•
Turn the cooktop on and off only after the power
supply is connected.
•
Do not let water droplets end up on the appliance.
and
•
Make sure that valve cables are not located near the
high voltage cables of ignition transformer.
•
Before switching on make sure that there are no
foreign objects on the cooktop, particularly, in the
control panel area.
•
After the cooktop is turned on, wait for a few seconds
for the process of control panel automatic calibration
to be completed.
In case of "partial" short circuit or insufficient
•
insulation between line and earthing, voltage on the
sensor electrode may drop to a level when appliance
interlock is initiated, because it is not possible to
accept the ignition signal.
•
Touching the extra-low voltage (ELV) circuit is
dangerous (only basic insulation as per EN 60730-1
is provided). Therefore, the appliance must ensure a
level of electrical discharge protection for the user
interface that is equivalent to double insulation.
IMPORTANT: for correct cooktop installation,
adjustment or modification for use with different
types of gas, contact a QUALIFIED INSTALLER.
Failure to meet this requirement results in
warranty cancellation.
E
F
55 min
70 min
13
Publicidad
Tabla de contenido
