Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7) GAS SUPPLY
Before installing the appliance, make sure that data
on the factory label inside the box correspond to
gas mains specifications. Data for appliance
adjustment are given on the label shown in this
manual and located inside the box: type of gas and
working pressure.
If gas is supplied via a pipeline, the appliance must
be connected to a gas supply device:
•
Using a rigid steel pipe, in compliance with applicable
standards, connections must be made using screw
fittings in compliance with EN 10226.
•
Using a copper pipe, in line with applicable standards,
connections must be made with mechanically sealed
fittings, in compliance with applicable standards.
•
Using a flexible stainless steel pipe with solid walls, in
compliance with applicable standards, maximum 2
meters in length, with sealing gasket in compliance
with applicable standards. This pipe must be installed
so as to prevent touching movable parts of the built-in
module (for example, drawers) and crossing areas
where objects can be located.
Gasket
Nut
Metal gas supply pipe
Warning: it is prohibited to connect phase and neutral in different
lines!
INSTALLATION
Pipeline bend
Fitting
EARTHING
Wrong!
If gas is supplied directly from the canister, the
appliance must be fitted with a pressure regulator in
compliance with applicable standards, and must be
connected as follows:
•
Using a copper pipe, in line with applicable
standards,
connections must
mechanically sealed fittings, in compliance with
applicable standards.
•
Using flexible stainless steel pipes with solid walls,
in compliance with applicable standards, maximum
2 meters in length, with sealing gasket in compliance
with applicable standards. This pipe must be
installed so as to prevent touching movable parts of
the built-in module (for example, drawers) and
crossing areas where objects can be located. To
make connection of the pressure regulator installed
on canister with the connecting nozzle easier, it is
recommended to install a special adapter on flexible
pipe. This type of adapter is readily available in
stores.
After connection make sure that it is completely leak-
tight using soap solution. Using flame for checking is
prohibited.
WARNING:
Please note that the fitting on appliance gas inlet
port has a 1\2" thread, conical, male, in compliance
with standard EN 10226.
IMPORTANT:
The appliance conforms to provisions of additional
legal regulations to European Union directives:
- Regulation (UE) 2016/426.
Correct!
16
be made
with
EARTHING
Publicidad
Tabla de contenido
