Preparing The Opening - Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario

Ocultar thumbs

página de 97

/ 97
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

WARNING

Tools Needed:

Recommended

ATTACH A SUITABLE MOUNTING PAD TO

tools from

STRUCTURALLY SOUND FRAMING COULD CAUSE

page 5

SPRINGS TO VIOLENTLY PULL MOUNTING PAD

FROM WALL, RESULTING IN SEVERE OR FATAL

INJURY.

If you just removed your existing door or you are installing a

new door, complete all steps in PREPARING THE OPENING.

For detailed technical information regarding the opening

preparation, refer to the DASMA Technical Data Sheet TDS

#161 "Connecting Garage Door Jambs to Building Framing"

at www.dasma.com.

The inside of your garage door opening should be framed with

wood jambs and header. It is recommended that 2" x 6" lumber

be used. The jambs must be plumb and the header level. The

jambs should extend a minimum of 12" (305 mm) above the

top of the opening for TorqueMaster

For low headroom applications, the jambs should extend to

the ceiling height. Minimum side clearance required, from the

opening to the wall, is 3-1/2" (89 mm).

IMPORTANT: CLOSELY INSPECT JAMBS, HEADER AND

MOUNTING SURFACE. ANY WOOD FOUND NOT TO BE SOUND,

MUST BE REPLACED.

The jambs and header must be securely fastened to sound

framing members. Do not place jambs and header over drywall,

paneling, etc. Heads of fasteners must be flush or below jamb

and header surface, so they do not interfere with installation

or operation of new door.

TorqueMaster

surface must be firmly attached to the wall, above the header

at the center of the opening.

The mounting surface must be 2" x 6" lumber minimum (Select

southern yellow pine lumber. Do not use lumber marked as

spruce-pine-fur or SPF).

The mounting surface must be securely attached to block or

concrete wall with four (4) 3/8" masonry anchors or four (4)

5/16" x 4" lag screws for a wood structure.

NOTE: Drill a 3/16" pilot hole in the mounting surface to avoid

splitting the lumber. Do not attach the mounting surface with

nails.

WEATHER SEAL: Cut three (3) pieces of weather seal (may not

be included) to the jambs and header. Align the jamb seals with

the inside edge of the opening. Temporarily nail the weather

seal to the jamb to keep the bottom section from falling out of

the opening during installation.

NOTE: Do not permanently attach weather seal to the jamb

at this time.

HEADROOM REQUIREMENT: Headroom is defined as the space

needed above the top of the door for tracks, springs, etc. to allow

the door to open properly. If the door is to be motor operated,

2-1/2" (64 mm) of additional headroom is required.

NOTE: 6" LHR Conversion Kit is available for 12" Radius only.

Contact your local Wayne Dalton dealer.

BACKROOM REQUIREMENT: Backroom is defined as the

distance needed from the opening back into the garage to

allow the door to open fully.

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com