Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 22

17
TorqueMaster
Tools Needed:
TorqueMaster
and pre-assembled inside the
None
TorqueMaster
the TorqueMaster
floor (inside garage) in front of the door
with the labeled end to the left.
18
Center Bracket Bushing
Tools Needed:
NOTE: If you are installing the idrive
opener on your garage door, skip this
None
step and continue with Step 19.
NOTE: If you are not installing the
idrive
®
must install the center bracket bushing
assembly. Follow these instructions for
non-idrive
NOTE: If you are installing a
DoorMaster
DoorMaster
page 40, Figure A.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly
towards the center of the TorqueMaster
spring tube, from the right side as
shown.
NOTE: Upon completion of this step,
continue with Step 20.
22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Spring Tube
®
springs come lubricated
®
spring tube. To install, lay
®
spring tube on the
®
®
opener on your garage door, you
® operated garage doors.
opener, see optional
™
Bracket installations on
™
LABELED END
TORQUEMASTER ®
SPRING TUBE
®
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
BUSHING