Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 27

23
Securing Center Bracket
Assembly
CENTER
BRACKET
BUSHING
NOTE: If you are installing the idrive
Tools Needed: ®
ASSEMBLY
opener on your garage door, skip this step
Power Drill
and continue with Step 24.
1/8" Drill Bit
NOTE: If you are not installing the
7/16" Socket
idrive
opener on your garage door, you
®
Driver
must install the center bracket bushing
assembly. Follow these instructions for
non-idrive operated garage doors.
®
NOTE: If you are installing a DoorMaster
™
opener, see optional DoorMaster Bracket
™
installations on page 40, Figure B.
To locate the center bracket, mark the
header halfway between the flagangles
and level the TorqueMaster spring tube.
®
Drill 1/8" pilot holes into header for the
lag screws. Fasten the metal bracket to
the header using (2) 5/16" X 1-5/8" lag
(2) 5/16" X 1-5/8"
screws.
HEX HEAD LAG
SCREWS
NOTE: Upon completion of this step, con-
tinue with Step 28.
27
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com