Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 6

P1
Torsion Spring Removal
WARNING
Tools Needed:
Approved FAILURE TO USE APPROVED
Winding Bars WINDING BARS CAN CAUSE SPRING
ENERGY TO BE RELEASED
SUDDENLY, RESULTING IN SEVERE
3/8" Wrench
OR FATAL INJURY.
WARNING
Vice Clamp
COUNTERBALANCE SPRING
TENSION MUST BE RELIEVED
Recommended BEFORE REMOVING ANY
tools from
HARDWARE. A POWERFUL SPRING
page 5
RELEASING IT'S ENERGY SUDDENLY
CAN CAUSE SEVERE OR FATAL
INJURY.
Do not release the torsion spring
tension unless you are qualified and
experienced door technician. Instead have
a professional door agency release the
tension.
Step 1: Close the door and place vice
clamps on the back legs of both vertical
tracks, above the third roller to prevent the
door from lifting as you unwind the springs.
Use only approved winding bars available
from your dealer. Do not use undersized
steel rods, screw drivers or anything else
to unwind the springs. Position the ladder
just off to the side of the winding cone.
The winding cone should be easy to reach
without putting your body directly in front
of it.
Step 2: Insert a winding bar into one of the
holes in the winding cone. Exert upward
pressure. Using caution, loosen the two
(2) set screws in the winding cone. Be
prepared to support the full torsional force
of the spring when the set screws are
loosened.
Step 3: Once set screws are loose, slowly
and carefully lower the winding rod until it
contacts the door. Insert other winding bar
into the upper hole. Push up and remove
lower bar. Carefully lower upper winding
bar, 1/4 turns at a time until it contacts
the door. Repeat process until all tension
is relieved. If your door is equipped with
two (2) torsion springs, follow the same
procedure to relieve tension on the second
spring.
Step 4: Remove vice clamps from tracks,
unbolt torsion shaft assembly and remove
from work area.
NOTE: Continue with "P4" on page 9 after
completing this step.
6
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
For Standard Lift
TORSION SPRING ASSEMBLY
WINDING CONE
APPROVED WINDING BAR
SET SCREWS
FIRMLY HOLD WINDING BARS AND
CAUTIOUSLY LOOSEN SET SCREWS