Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 28

24
Positioning Support Bracket
NOTE: See idrive
Tools Needed:
instructions and owner's manual for
Power Drill
idrive
®
1/8" Drill Bit
NOTE: idrive
7/16" Socket
solid mounting surface.
Driver
Locate the mounting surface. The
mounting surface is a vertical board
running directly above the center of the
door. Remove (2) 1/4"-20 flange nuts
from bottom of opener.
NOTE: Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. Using a
tape measure, level the bottom of the
TorqueMaster
the door section with the idrive
on the support bracket. Once
TorqueMaster
1/8" pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4" x 1-1/2" lag
screws.
IMPORTANT: TORQUEMASTER
TUBE MUST BE LEVEL AFTER SUPPORT
BRACKET IS FASTEN TO MOUNTING
SURFACE.
NOTE: If wood mounting surface is
behind dry wall, use 1/4" x 2" lag
screws.
Lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. Loosely
fasten to mounting studs with the (2)
1/4"-20 flange nuts.
NOTE: Do not tighten 1/4"-20 flange
nuts to opener studs at this time.
Remove the temporary orange label
holding the antenna wire. Straighten
antenna wire and angle it 45 degrees to
the right.
NOTE: Do not coil the antenna wire.
This will reduce the radio signal range.
28
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
main installation
®
parts.
must be installed on a
®
spring tube to the top of
®
resting
®
® spring tube is level, drill
SPRING
®
45° ANGLE
1/4 X 1-1/2"
LAG
SCREWS
(HEADER)
TOP OF DOOR
TORQUEMASTER
®
SPRING TUBE
"X"
USING A TAPE MEASURE, MAINTAIN AN EQUAL MEASUREMENT "X"
(TOP OF DOOR TO BOTTOM OF TORQUEMASTER® TUBE) AT BOTH
ENDS AND THE CENTER.
ANTENNA WIRE
TORQUEMASTER
SPRING TUBE
SUPPORT
BRACKET
1/4" - 20
FLANGE
NUTS
MOUNTING
STUDS
MOUNTING
BRACKET
STUDS
SLOTS
(2) 1/4" - 20
FLANGE NUTS
"X"
TOP SECTION
MOUNTING
SURFACE
®
SUPPORT
BRACKET
"X"