Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 12

2
Attaching Fully Adjustable
Flagangles to Vertical Track
Tools Needed:
NOTE: If quick install flagangles was
installed in Step 1, skip this step and
None
continue with Step 3. If not, complete
this step.
Hand tighten the flagangle to the vertical
track using (2) 1/4" - 20 x 9/16" large
head ribbed track bolts and (2) 1/4" - 20
flange hex nuts. Repeat for other side.
Secure the flange nuts after flagangle
spacing is complete (Step 13).
3
Tools Needed:
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key
Hammer
slot of horizontal track. Using a hammer,
tap the horizontal angle towards the
curved end of the track until the hole in
track and angle are aligned. Set tracks
aside.
NOTE: For larger doors, a full length
horizontal angle may not be spot welded
to the horizontal track. If the horizontal
angle is not welded, the horizontal angle
will be installed as shown.
NOTE: If you have riveted track, skip
step 4 and proceed to step5.
12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Horizontal Angle
FULLY ADJUSTABLE FLAGANGLE
1/4"- 20
FLANGE HEX
NUTS
VERITCAL TRACK
TABS
HOLE
HORIZONTAL TRACK
HORIZONTAL ANGLE
1/4" - 20 X 9/16"
LARGE HEAD RIBBED
TRACK BOLTS
HORIZONTAL
ANGLE
KEY SLOT
HOLE
HORIZONTAL
TRACK
HORIZONTAL
HORIZONTAL
TRACK
ANGLE
HORIZONTAL
TRACK
TABS