About The Input Connectors On This Unit; Connection To Input1 (D-Sub) And Input5 - Pioneer Elite PRO-1010HD Manual De Instrucciones

CAUTION
÷ Handles should not be removed or reattached by
anyone other than the professional installation
technician or service personnel.
÷ If handles must be removed due to specific installation
conditions, the mounting screws should be stored
carefully together with the handles. To ensure safety,
the mounting screws should be tightened to a
minimum torque of 2N·m (20 kgf·cm) when reattaching
the handles.
÷ When moving the display, it should always be carried
by two persons holding the rear handles in the manner
shown.
NO!
÷ Never attempt to move the plasma display by holding
only one of the handles.
÷ When installing the plasma display, do not use the
handles as means of hanging the display; also do not
use them as devices to prevent tipping over (see
illustration).
About the Input Connectors on this
Unit
Consult the following chart when making connections to
a plasma display (pages 12 to 21).
Input Connector INPUT1
Connected
(D-sub)
component and signals
Analog RGB
Component video
S-video
Composite video
Digital video
*2
Analog RGB
S-video
Composite video
*1 *4
INPUT1 INPUT INPUT INPUT INPUT
*4 *1
(HDMI) 2 3 4 5
*3
*3
Installation and Connections
*1 Although INPUT1 (D-sub)/INPUT5 are compatible with
various kinds of signals, setup using the on-screen menu is
necessary after connections are made in order match the
characteristics of the source component (pages 23 to 25).
*2 INPUT1 (D-sub) is compatible with Microsoft's Plug & Play
(VESA DDC 1/2B).
*3 Depending on the video output board of the computer, this
type of connection may not be possible.
*4 Although INPUT1 (HDMI)/INPUT2 are compatible with
various kinds of signals, setup using the on-screen menu is
necessary after connections are made in order match the
characteristics of the source component (pages 25 to 27).
Connection to INPUT1 (D-sub) and
INPUT5
Various components can be connected to the INPUT1(D-
sub) and INPUT5 jacks. After connections are made, on-
screen setup is necessary to match the characteristics of
the connected component. Please see pages 23 to 25 for
on-screen setup after connection.
INPUT5 terminal
[ON SYNC]
Output source
G
Video component/
G ON SYNC
Personal
computer (PC)
G
with RGB output
G
Video component
with component
Y
video output
: Do not connect anything.
Note
Components compatible with INPUT1 (D-sub) are also
compatible with INPUT5.
When making connections to INPUT1 (D-sub), please refer to
appendix 3 on page 55.
For the screen sizes and input signals that INPUT1
(D-sub) and INPUT5 are compatible with, please
refer to appendix 1 (page 52) and appendix 2 (pages
53 to 54).
Stabilizing to the floor
÷ Use screws (sold separately) to attach and stabilize the stand.
÷ When stabilizing the stand to the floor, use M6 with a length
above 20 mm (25/32 inch).
Units: mm (inch)
[H/V SYNC]
B R HD VD
B R
B R H/V SYNC
B R HD VD
C /P C /P
B B R R
: Connect to this jack.
11
EN