Basic Operations; Power; To Turn The Unit On And Off; Volume - Pioneer PDP-42MVE1 Manual De Instrucciones

Basic Operations

POWER

To turn the unit ON and OFF:

1. Plug the power cord into an active AC power outlet.
2. Press the Power button (on the unit).
The monitor's STANDBY/ON indicator turns red and the
standby mode is set.
3. Press the POWER ON button (on the remote control) to
turn on the unit.
The monitor's STANDBY/ON indicator will light up
(green) when the unit is on.
4. Press the POWER STANDBY button (on the remote control)
or the Power button (on the unit) to turn off the unit.
The monitor's STANDBY/ON indicator turns red and the
standby mode is set (only when turning off the unit with
the remote control).

VOLUME

To adjust the sound volume:

1. Press and hold the VOLUME
control or the unit) to increase to the desired level.
2. Press and hold the VOLUME
control or the unit) to decrease to the desired level.

MUTING

To mute the sound:

Press the MUTING button on the remote control to mute
the sound; press again to restore.

DISPLAY

To check the settings:

1. The screen changes each time the DISPLAY button is
pressed.
2. If the button is not pressed for approximately three seconds,
the menu turns off.

DIGITAL ZOOM

Digital zoom specifies the picture position and enlarges
the picture.
1. Press the POINT ZOOM button to display the pointer.
( )
To change the size of the picture:
Press the ZOOM+ button and enlarge the picture.
The pointer will change to resemble a magnifying glass.
( )
A press of the ZOOM- button will reduce the picture
and return it to its original size.
To change the picture position:
Select the position with the LM
2. Press the POINT ZOOM button to delete the pointer.

AUTO SET UP

To adjust the size or quality of the picture
automatically:
Press the AUTO SET UP button.
Information
AUTO SET UP ON setting
When RGB (still picture) input is selected:
PHASE, CLOCK, Position, and Contrast will be
adjusted automatically.
When RGB (motion picture), VIDEO, or Y/Pb/Pr
(component) input is selected:
The screen size switches to ZOOM mode automatically
with the superimposed caption displayed fully only
when the picture contains dark areas above and below
the picture.
8
En

OFF TIMER

To set the off timer:

The off timer can be set to turn the power off after 30, 60,
90 or 120 minutes.
1. Press the OFF TIMER button to start the timer at 30
2. Press the OFF TIMER button to the desired time.
3. The timer starts when the menu turns off.
button (on the remote

To check the remaining time:

1. Once the off timer has been set, press the OFF TIMER
button (on the remote
2. The remaining time is displayed, then turns off after a few
3. When five minutes remain the remaining time appears

To cancel the off timer:

1. Press the OFF TIMER button twice in a row.
2. The off timer is canceled.
Note:
buttons.
minutes.
→ → → → →
30 60 90 120 0
OFF TIMER 30
button once.
seconds.
until it reaches zero.
OFF TIMER 28
OFF TIMER 0
After the power is turned off with the off timer ...
A slight current is still supplied to the monitor. When you
are leaving the room or do not plan to use the system for a
long period of time, turn off the power of the monitor.