Pioneer Elite PRO-1010HD Manual De Instrucciones página 28

System Settings
1
Select INPUT1 (D-sub), or INPUT5.
2
Press the MENU button to display the menu screen.
STANDARD
PICTURE SCREEN
CONTRAST
BRIGHTNESS
COLOR
TINT
SHARPNESS
MPEG NR
DNR
CTI
PICTURE RESET
ENTER
SET
3 Use the 2/3 buttons to select [SETUP].
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
ENTER
SET
4 Use the 5/∞ buttons to select [SIGNAL FORMAT],
then press the SET button.
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
5 Use the 2/3 buttons to select the display mode.
S I G N A L F O R M AT
SET SET
1 When the input signal has a refresh rate of 31.5 kHz
horizontal / 60 Hz vertical, pressing 2/3 will cause
the display mode to change alternately as follows:
3 480p 2
3 WVGA 2
24
EN
INPUT1
SETUP OPTION
:
0
:
0
:
0
:
0
:
0
:
MID
:
MID
:
ON
EXIT
MENU
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
480p
:
COMPONENT
:
ON
EXIT
MENU
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
480p
:
COMPONENT
:
ON
:
480p
MENU EXIT
3 VGA 2
2 When providing input signals with refresh rates of
45 kHz horizontal / 60 Hz Vertical, pressing the 2/3
buttons causes the display mode to alternate as
follows:
3 720p 2
[720-PC] indicates resolution of 1280 x 720.
3 When the input signal has a refresh rate of 48.4
kHz horizontal / 60 Hz vertical, or 56.1 kHz
horizontal / 70 Hz vertical, pressing 2/3 will cause
the display mode to change alternately as follows:
3 XGA 2
3 PC AUTO 2
If the [PC AUTO] setting is selected, screen
resolution will automatically switch between [XGA]
and [WXGA] as required.
Notes
÷ The [PC AUTO] setting supports automatic signal selection
only when using RGB separate SYNC inputs.
÷ When G ON SYNC or Composite SYNC signals are input,
selecting [PC AUTO] will cause the screen resolution to be set
to [XGA] only.
÷ When using G ON SYNC or Composite SYNC with WXGA
inputs, set [SIGNAL FORMAT] manually to [WXGA].
6
Press the SET button.
The setting is stored in memory and the screen
returns to that shown in step 4.
7
When a component other than a computer is
connected, use the 5/∞ buttons to select [COLOR
DECODING] then press the SET button (INPUT1
(D-sub) or INPUT5).
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
8 Use the 2/3 buttons to select the input signal
format.
COLOR DECODING
SET
SET
Each time you press the 2/3 buttons, the setting
changes as follows:
3 COMPONENT 2
The table below shows what settings are appropriate
and available for the type of connections made.
3 720-PC 2
3 WXGA 2
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
480p
:
COMPONENT
:
ON
: COMPONENT
EXIT
MENU
3 RGB 2