Screen Size Operation With Computer Signals - Pioneer PDP-6100HD Manual De Instrucciones

SCREEN SIZE Operation with
Computer Signals
Switch to the wide screen mode to expand the 4 : 3 image
to fill the entire screen.
1. Press the SCREEN SIZE button on the remote control.
2. Within 3 seconds ...
Press the SCREEN SIZE button again.
The screen size switches as follows:
→ 4:3 → FULL → ZOOM
When displaying enhanced split screen:
↔
4:3 FULL
4:3 size screen (4:3 or SXGA 5:4)
The picture has the same size as the normal computer
image.
FULL size screen
The image is expanded in the horizontal direction.
ZOOM size screen
When wide signals are input.
FULL size screen
Information
Supported resolution
See page 27 for details on the display output of the
various VESA signal standards supported by the
monitor.
"D BY D" , a way of displaying pixels in a one-to-one
correspondence with input signals, can be switched only
when a 1280 dot x 768 line signal is input.
When 852 (848) dot
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT mode
referring to the"Table of Signals Supported" on page
27.
* "VGA", "SVGA" and "SXGA" are registered
trademarks of IBM, Inc. of the United States.
Note:
Do not allow the displayed in 4:3 mode for an extended
period. This can cause a phosphor burn-in.
480 line wide VGA*
9
En