Setting The Test Reminders - Accu-Chek Nano Manual Del Usuario

5
Meter Memory, Setup, and Data Transfer

Setting the Test Reminders

NOTE
Test reminders:
• beep at the same time each day.
• beep every 2 minutes up to 3 times.
• turn o by inserting a test strip or pressing any
button.
1
Turn the meter on.
The flashing test strip
symbol appears on the
display.
Press and hold
until
set-up appears on the
display.
5
Press and release or
to switch between am
and pm.
Press and release to set
am or pm.
30
2
Press and release
repeatedly until the bell
symbol, OFF, set-up, and
the flashing A-1 appear.
6
The bell symbol, OFF, and
the flashing A-2 appear
on the display.
Either set the A-2 test
reminder or press and
release to set up more
options.
• If a test was performed within 15 minutes of a test
reminder, the test reminder does not beep.
• If the meter is on at the test reminder time, the test
reminder does not beep.
• Exposure to cold conditions may disable test
reminders until the meter is turned on.
3
Press and release or
to switch between On
and OFF.
Press and release to set
your choice.
If On is selected, the hour
flashes.
Press and release or
to adjust the hour.
Press and release to set
the hour.
7
To exit, press and hold
until the flashing test strip
symbol appears on the
display.
4
The minutes flash.
Press and release or
to select 00, 15, 30, or
45. These are the only
choices.
Press and release to set
the minutes.
Am or pm flashes on the
display.