Transferring Results To A Computer - Accu-Chek Nano Manual Del Usuario

5
Meter Memory, Setup, and Data Transfer

Transferring Results to a Computer

We o er a variety of software to help you transfer your results. For information on Accu-Chek software, contact
the Accu-Chek Customer Care Service Center at 1-800-858-8072.
You can transfer your stored results to a computer to track, identify patterns, and print.
Transferring Data Directly to a Computer Using Specialized Software and an Infrared Cable
1. Install the software according to the
instructions.
2. To transfer the results to a computer, connect
the infrared cable according to the instructions.
3. Run the software program and follow the
instructions for data transfer. Make sure the
software is ready to accept data from the
meter.
4. With the meter off, press and hold both
and until 2 arrows on the display
alternately flash.
5. Locate the infrared (IR) window on the top of
the meter.
NOTE
• If the data did not transfer successfully, try again. Contact the Accu-Chek Customer Care Service Center at
1-800-858-8072 if you still have problems.
• To make the most of the transfer feature, make sure the meter is set to the correct time and date.
32
6. Locate the IR window on the infrared cable.
7. Place the meter on a flat surface. Point the 2 IR
windows toward each other. They should be
1–4 inches apart.
8. Do not move the infrared cable or meter during
the data transfer.
9. Follow the prompts on the software.
10. The software program may shut off the meter
automatically when the data transfer is
complete. Should this occur, follow the prompts
on the display.