Zodiac eXPERT Manual De Instalación Y De Uso página 57

2.4.2. Installing the pH minus suction line
• Cut a suitable length of transparent hose from the coil (supplied) to connect the container of pH-minus to the pH
pump.
• Unscrew the connector cap and attach the hose to the connector at the inlet of the pH pump, see figure
the cap in place.
• Drill two holes into the cap of the pH minus container, see figure
- One hole suitable for the diameter of the hose (
- One smaller hole to prevent the container from becoming deformed during aspiration of the product.
• Pass the free end of the suction hose (
vided ( ) and the support tip on the hose, see figure
• Ensure that all connections are correct and watertight before operating the appliance.
Do not place the pH-minus container directly beneath electrical equipment in the technical room to prevent
risk of corrosion resulting from potential acidic vapours.
:
)to aspirate the product.
) through the hole made in the cap (
.
) and put the ceramic weight pro-
pH-minus
. Screw
EN
14